MODEL C24EA - DOOR
2.Install outer door housing assembly as outlined in DOOR HANDLE.
3.Check opening and closing operation of door.
4.Check steamer for proper operation and leaks around door seal.
A.Press hinge bearing fully into door assembly using a
10.Reassemble parts removed in reverse order.
11.Check door for fit and proper door gasket sealing.
HINGE BEARINGS
1.Close door.
2.Remove LEFT SIDE PANEL as outlined in
COVERS AND PANELS.
3.Remove nuts from upper hinge located inside front panel.
4.Open door slightly, and while holding door, pull upper hinge away from front panel.
5.Pull upper hinge out of upper door hinge bearing.
6.Lift door assembly up and off lower door hinge.
7.Pry hinge bearing out from door assembly.
8.Remove outer door housing.
CAUTION: Do not drive bearing into place. The inner door panel could be damaged. Press bearing into position.
NOTE: When replacing door hinge bearings, replace both hinge bearings.
9.Position replacement hinge bearing over hinge opening in door assembly.
DOOR LATCH ADJUSTMENT
Opening a Jammed Door
CAUTION: Should the steamer door jam and cannot be opened, DO NOT FORCE OR PRY the door as damage will occur.
1.Lift up on bottom of door at the handle end to disengage latch.
A.If door does not open, remove the right side panel as outlined in RIGHT AND LEFT SIDE PANELS.
B.Locate the striker that catches on door latch near steam chamber on front panel.
C.Remove the nut from striker and this should release it from the panel.
D. Open door.
2.Remove striker.
3.Remove any burrs on striker that may cause latch to stick.
4.Apply Loctite 271 to threads of striker.
5.Reinstall striker with slotted side up. Snug striker nut. Perform Adjustment, so door will not jam.
Page 11 of 52 |
| F25213 (May 2006) |
|