Vulcan-Hart C24EA5 480V BASIC Filtered And Non-Filtered Water Solenoid Valves, Valve Type

MODEL C24EA - WATER LEVEL CONTROL COMPONENTS

NOTE: Perform a steam generator tank cleaning as outlined under STEAM GENERATOR TANK -

CLEANING.

DUAL WATER VALVE FLOW RATES

Valve Type	Machine	Flow Rate (GPM)
		Fast Flow	Slow Flow
	Type	Valve	Valve
Fill (Filtered	3 & 5 Pan	4.8	0.15
Water)
Condensate	3 - Pan	4.8	0.75
(Non-Filtered
	5 - Pan	4.8	1.35
Water)

Filtered Water Solenoid Valve

1.Turn off machine to drain steam generator tank. Allow steamer to complete drain cycle.

A. Turn off water supply.

2.Disconnect the incoming filtered water hose to machine.

FILTERED AND NON-FILTERED

WATER SOLENOID VALVES

WARNING: DISCONNECT THE

ELECTRICAL POWER TO THE

MACHINE AND FOLLOW LOCKOUT /

TAGOUT PROCEDURES.

NOTE: The filtered and non-filtered water solenoid valves are constructed as dual water valve assemblies. To differentiate between the fast and slow fill valves, hold the dual water valve assembly with the inlet up and the outlets facing forward. The fast flow valve is the left valve and the slow flow valve is the right valve. The two dual assemblies used on the steamer have different flow rates and should not be interchanged.

3.Remove the REAR PANEL as outlined under

COVERS AND PANELS.

4.Remove the screws securing the solenoid valve to the back plate.

5.Pull solenoid valve toward right side of machine enough to access electrical connections.

A.Note connection points of electrical wires then disconnect wires from solenoid valve.

B.Disconnect hoses from solenoid valve then remove solenoid valve from steamer.

DUAL WATER VALVE

F25213 (May 2006) Page 24 of 52