JWDSK Series | Installation Instructions |
|
|
Steel Stud |
Drywall |
Plastic Cap |
Plastic Straps |
Anchor Metal Channel |
SIDE VIEW |
Figure 5
11.Place mount over anchors and align mounting holes in display mount with holes in anchors. (See Figure 6)
12.Place flat washer (E) onto Phillips pan head screws (D).
13.Insert
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Overtightening of mounting hardware can damage the steel studs. DO NOT overtighten mounting hardware!
Steel Stud |
Drywall |
(E) x 4 |
(D) x 4 |
Display Mount |
Anchor Metal Channel |
SIDE VIEW |
Figure 6
Display Installation
1.Determine mounting pattern on display.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
WARNING: IMPROPER INSTALLATION CAN LEAD TO ELECTRIC SHOCK OR DAMAGE TO EQUIPMENT! Screw length must not exceed the depth of threaded mounting insert in display.
WARNING: OVERTIGHTENING OF SCREWS CAN DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface bracket.
NOTE: If the display being installed has a 100x100 VESA mounting pattern, no interface bracket is required and the display can be mounted directly to the mounting plate as outlined below.
NOTE: If the display being installed requires an interface bracket, refer to the interface bracket installation instructions.
WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Using screws of improper size may damage your display! Proper screws will easily and completely thread into display mounting holes. Ensure that screws are not too long.
WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread engagement in display may cause display to fall! Back out screws ONLY as necessary to allow installation of mounting plate!
1.Start two M4 x 12mm Phillips pan head screws (included in hardware kit) into upper mounting holes in display back. (See Figure 7)
NOTE: Leave at least 1/8" of each screw protruding out back of display.
6
