Installation Instructions | JWDSK Series |
1 | x2 |
Figure 7
2.Align two screws in display back with upper teardrop mounting holes in mounting plate.
3.Place two screws in display back into upper teardrop mounting holes in display mounting plate and lower display until screws are seated in lower area of teardrop mounting holes. (See Figure 8)
4.Install two screws through display mounting plate and into lower mounting holes in display back. (See Figure 8)
5.Tighten all hardware.
| 2 |
| 3 |
4 | x 2 |
Figure 8
6.Route cables and wires to display.
CABLE MANAGEMENT
1.Attach all cables to display.
CAUTION: Ensure that adequate cable slack exists for movement of display, and that cables will not be pinched by installation of cover (B) or screws (C).
2.Carefully insert cables in cavity located in lower portion of mount arm (See Figure 9).
3.Using Phillips screwdriver, install cover (B) with two screws
(C). (See Figure 9)
Cable Path |
(typical) |
(B) x 2 |
(C) x 4 |
Figure 9
ADJUSTMENTS
Swing Arm
PIVOT / SWING
1.Using 3/16" hex key (G), slightly loosen or tighten the adjustment screw(s) as necessary. (See Figure 10)
Adjustment Screws |
Figure 10
7
