Figure H | Harbor Freight Tools 05154 specs

WORK TABLE (13)

ANGLE PLATE (14)

LOCK

SCREW

(15)

FIGURE H

To Adjust The Angle Of The Miter Guide:

1.The angle of the Miter Guide (21) may be adjusted to the right 0 to 45 degrees and to the left 0 to 45 degrees. (See Figure I.)

2.To adjust the angle of the Miter Guide (21), slightly loosen the Miter Guide Knob (22). (See Figure I.)

3.Observe the gauge on the Miter Guide (21). Move the Miter Guide to the right or left until the desired angle is indicated on the gauge. Then, retighten the Miter Guide Knob (22) to lock the Miter Guide in place. (See Figure I.)

MITER GUIDE KNOB (22)

MITER GUIDE (21)

FIGURE I

SKU 05154

PAGE 13

Image 13

Harbor Freight Tools 05154 operating instructions Figure H, To Adjust The Angle Of The Miter Guide

Contents

For technical questions, please call Sander 4 Belt & 6 Disc General Safety Rules Product SpecificationsSave this Manual Unpacking Personal Safety Electrical Safety Tool USE and Care Grounding ServiceGrounded Tools Tools with Three Prong Plugs Figure a Double Insulated Tools Tools with TWO Prong Plugs Extension Cords Figure C See Figure C Specific Safety Rules SymbologyDo not allow children to handle or play with this product Industrial applications must follow Osha requirements Page Assembly Diagram on Assembly and Operating InstructionsTo Install a Sanding Belt See Figures E and F To Adjust The Angle Of The Work Table To Install a Sanding DiscSee Figure G Figure H To Adjust The Angle Of The Miter Guide To Perform Horizontal Sanding With The Sanding Belt To Adjust For Vertical SandingSee Figure K, next See Figure K See Figure L, next To Perform Vertical Sanding With The Sanding BeltSee Figure L See Figure M, next To Perform Horizontal Sanding With The Sanding DiscSee Figure M Figure M INSPECTION, MAINTENANCE, and Cleaning Please Read the Following Carefully Description Qty Parts List Assembly Diagram & Wiring Schematic