Harbor Freight Tools 05154 operating instructions

21.Allow the Sanding Disc (11) and Sanding Belt (45) to spin up to full speed before feeding a workpiece into them. When turning off the Sander, allow the Sanding Disc and Sanding Belt to slow down and stop on their own. Do not press against the Disc or Belt to stop them.

22.Feed the workpiece into the Sanding Disc (12) and Sanding Belt (45) gradually and into the direction of rotation. Do not attempt to force the Sander to remove material faster than it was designed to cut.

23.To avoid damage to the machine, allow approximately 1/16” clearance between the Sanding Belt (45) and Work Support (33). Also allow approxi- mately 1/16” clearance between the Sanding Disc (12) and the Work Table (13).

24.When sanding a large workpiece, make sure its entire length is properly supported.

25.Never attempt to remove material stuck in the moving parts of the Sander while it is plugged in and running.

26.Always turn the Power Switch (30) to its “OFF” position and unplug the Power Cord (29) from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.

25. WARNING! Some dust created by power sanding, sawing, grinding, drilling and other construction activities, contain chemicals known (to the State of Cali- fornia) to cause cancer, birth defects or other reproductive harm. Some ex- amples of these chemicals are: lead from lead-based paints, crystalline silica from bricks and cement or other masonry products, arsenic and chromium from chemically treated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. (California Health & Safety Code 25249.5, et seq.)

47. WARNING! People with pacemakers should consult their physician(s) before using this product. Electromagnetic fields in close proximity to a heart pacemaker could cause interference to or failure of the pacemaker. In addition, people with pacemakers should adhere to the following:

A.Avoid operating this product alone.

B.Do not use this product with the Power Switch locked on.

C.Be certain that this product is properly grounded. A ground fault interrupt (GFCI) system is also a good precaution. This inexpensive device is a good safety measure because it prevents a sustained electrical shock.

D.Properly maintain and inspect this product before use to avoid electric shock.

SKU 05154 PAGE 10