Sony AR-B1570 manual Utility Diskette, Driver Installation

AR-B1570 User’s Guide

4. INSTALLATION

This chapter describes the installation procedure. The following topics are covered:

!Overview

!Utility Diskettes

!Watchdog Timer Setting

4.1OVERVIEW

This chapter provides information for you to set up a working system based on the AR-B1570 CPU board. Please carefully read the details of the CPU board’s hardware descriptions before installation. Pay special attention to the jumper settings, switch settings and cable connections.

Follow steps listed below for proper installation:

Step 1: Read the CPU board’s hardware description in this manual.

Step 2: Set jumpers.

Step 3: Make sure that the power supply connected to your AR-B1570 CPU board is turned off.

Step 4: Connect all necessary cables. Make sure that the HDC; serial and parallel cables are connected to pin 1 of the related connector (not upside down).

Step 5: Connect the hard disk flat cables from the CPU board to the drives. Connect a power source to drive.

Step 6: Plug the keyboard into the keyboard connector.

Step 7: Turn on the power.

Step 8: Configure your system with the BIOS Setup program (section 5) then re-boot your system.

Step 9: If the CPU board does not work, turn off the power and read the hardware description carefully again.

Step 10: If the CPU board still does not perform properly, return the board to your dealer for immediate service.

4.2 UTILITY DISKETTE

The AR-B1570 provides CD.

4.2.1 Driver Installation

The AR-B1570 provides LAN function drivers for the WIN95, WIN98, WIN2000, WINCE, LINUX, and NT. The driver can auto-setup in the specified mode. The user must first decompress the compressed file.

The 1st step: Decompress the zip files included in the CD to your hard disk.

The 2nd step: Execute the corresponding files to setup the system.

25