Installation Instructions |
|
|
| MSMVPU/LSMVPU | ||
WARNING: ELECTRICAL SHOCK HAZARD! CUTTING |
|
| Center of bracket | |||
OR DRILLING INTO ELECTRICAL CORDS OR CABLES |
|
|
| |||
CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY! |
|
|
| |||
ALWAYS make certain area behind mounting surface is free |
|
|
| |||
of electrical wires and cables before drilling or installing |
|
|
| |||
fasteners. |
|
|
|
|
| |
WARNING: EXPLOSION AND FIRE HAZARD! CUTTING |
|
|
| |||
OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH |
|
|
| |||
OR SERIOUS PERSONAL INJURY! ALWAYS make certain |
|
|
| |||
area behind mounting surface is free of gas, water, waste, or |
|
|
| |||
any other plumbing before cutting, drilling, or installing |
|
|
| |||
fasteners. |
|
|
|
|
| |
6 | (QA) x 2 | 5 |
|
|
| |
10 |
|
|
|
| ||
|
| 9 |
|
|
| |
|
|
| Pull straps |
| ||
(QB x 4) |
| 2 | or | x 4, x 6 or x8 | ||
|
|
|
| Figure 9 |
| |
7 |
|
| WARNING: IMPROPER INSTALLATION CAN LEAD TO | |||
(QC) x 2 | (R) | DISPLAY FALLING CAUSING SERIOUS PERSONAL | ||||
11 | ||||||
|
| INJURY OR DAMAGE TO EQUIPMENT! Using screws of | ||||
|
|
| improper size may damage your display. Properly sized | |||
|
|
| screws will easily and completely thread into display |
Figure 8
5.Drill one 5/16" pilot hole at each marking. (See Figure 8)
6.Install an anchor (QA) into each pilot hole using a hammer. (See Figure 8)
7.Use two 5/16 x
mounting holes. If spacers are required, be sure to use longer screws of the same diameter.
2.Select correct screws, spacers (if necessary) and universal washers from the hardware bag
NOTE: Uprights may need to be pulled out to the extended position in order to install screws through proper holes.
8.Mark the attachment points for the lower mounting slots. (See Figure 8)
9.Drill one pilot hole at each marking for lower mounting holes. (See Figure 8)
10.Install an anchor (QA) into each pilot hole using a hammer. (See Figure 8)
11.Use two 5/16 x
12.Slide rails to approximate center of screen location.
Attaching Interface Brackets to TV
1.Align the center of the
NOTE: The
Attaching Screen to Wall Mount
1.(LSMVPU only) Attach wall bracket caps (Y) to top and bottom of both wall brackets. (See Figure 10)
(Y) x 4 |
Figure 10
9