MSMVPU/LSMVPU | Installation Instructions |
3.Line up the notches on mount (R) with center of screen marking to determine vertical center. (See Figure 5)
Center of screen |
(190.5mm) |
Vertical center |
of mount |
Figure 5
4.Measure up
5.Using a level, mark the wall on each stud to attach the mount through the upper mounting slots. (See Figure 6)
5 |
Figure 6
WARNING: ELECTRICAL SHOCK HAZARD! CUTTING OR DRILLING INTO ELECTRICAL CORDS OR CABLES
CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY! ALWAYS make certain area behind mounting surface is free of electrical wires and cables before drilling or installing fasteners.
WARNING: EXPLOSION AND FIRE HAZARD! CUTTING OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY! ALWAYS make certain area behind mounting surface is free of gas, water, waste, or any other plumbing before cutting, drilling, or installing
fasteners. |
|
|
|
| 6 | 9 | x 4 |
|
|
| x |
7 |
|
|
|
(QC) x 2 |
|
|
|
10 | (QB x 4) |
|
|
|
|
| |
(QC) x 2 |
|
| (R) |
|
|
|
Figure 7
6.Drill one 7/32" pilot hole in each stud. (See Figure 7)
7.Use two 5/16 x
8.Mark the attachment points for the lower mounting slots, making sure the attachment points are located on the studs. (See Figure 7)
9.Drill 7/32" pilot holes at markings for lower mounting holes. (See Figure 7)
10.Use two 5/16 x
11.Slide rails to approximate center of screen location.
Installing MSMVPU to Wall - Concrete, Concrete Block
1.Determine the center of the TV screen, and where it should be located on the wall.
2.Line up the notches on mount (R) with center of screen marking to determine vertical center. (See Figure 8)
3.Measure up
4.Using a level, mark the wall through both upper mounting slots. (See Figure 8)
8