Installation Instructions |
|
RF Receiver Installation
Install RF reciever following the instructions provided with the receiver.
System Activation
1.Insert plug from the power supply into the jack on the top of the motor box.
24VDC Input |
Top of |
Cabinet |
Front of |
Cabinet |
Figure 9
2.Plug Powercord into 115VAC outlet. IMPORTANT ! : A quality surge protection device is recommended.
3.Make sure nothing is obstructing movement of doors,
4.Press and release the Activator Button on the front of the Motor Box or the "Close Door button on the Remote Control. (The doors should travel to the fully closed position)
Activator |
Figure 10
5.Press the "Open Door" button on the Remote Control.
NOTE: The mechanism has been preset to travel 34 inches. If a different travel distance is required see "Door Travel Adjustment below.
ADJUSTMENTS
Adjust Door Travel Distance
To adjust door travel distance:
1.Set the length of travel required using the adjustable stop on the bottom of the left hand track.
2.Press and hold the activator button on the front of the motor box for 13 seconds.
The Status Light on the front of the motor box will begin to blink alternately red and green. When this starts to happen release the Activator Button. When put into "Learn Moden the system runs back and forth several times and measures it's environment, such as open and closed locations etc. The system will then stop and remember these learned measurements.
Activator |
Figure 11
System Controls and Indicators
Learn Mode
The CM6SV system has no limit switches. The system uses an encoder on the motor to collect data and send it to the micro processor’s memory. The software "learns" about its environment (speed, time duration, stop points, etc.) during the initial setup of the unit and retains that information until requested to "relearn" its environment.
The unit is shipped
If for some reason you want to place the system into “Learn Mode” (such as to stop at other than its normal stop points), Press and hold the red activator button on the front of the motor box for approxamatly 13 seconds and then release it when the Status Light flashes quickly red, green, red, green, red, green.
Activator Button |
Figure 12
The controller will then be in “Learn Mode” (The door will move for 3 seconds, stop for 10 seconds, and when it starts moving again it will be in it’s “Learn Mode”).
When put into “Learn Mode” the mechanism runs back and forth several times and measures it’s environment, such as open and closed locations etc., and then stops and remembers
11
