BEVEL STOP ADJUSTMENT (FIG. O, P, Q)
! WARNING
To avoid injury from unexpected starting or electrical shock, make sure the trigger is released and remove the power cord from the power source.
90° Bevel Adjustment (Fig. O)
1.Loosen bevel lock handle (1) and tilt the cutting arm completely to the right. Tighten the bevel lock handle. Lower blade.
2.Place a combination square (2) on the miter table with the rule against the table and the heel of the square against the saw blade.
3.If the blade is not 90° square with the miter table, loosen the bevel lock handle, tilt the cutting head completely to the left, loosen the locknut (4) on the bevel angle adjustment bolt (3) and use a 13 mm wrench to adjust the bolt (3) in or out to increase or decrease the bevel angle.
4.Tilt the cutting arm to back to the right at 90° bevel and recheck for alignment.
5.Repeat steps 1 through 4 if further adjustment is needed.
6.Tighten bevel lock handle and locknut (4) when alignment is achieved.
Fig. O
1
3
4
2 
90° Bevel Indicator (Fig. P)
1.When the blade is exactly 90° to the table, loosen the bevel indicator screw (5) using a #2 Phillips screwdriver.
2.Adjust bevel indicator (6) to the “0” mark (7) on the bevel scale and retighten the screw.
Fig. P
7 | 6 |
| 5 |
45° Bevel Adjustment (Fig. Q)
1.Unlock the bevel lock handle (1) and tilt the cutting arm as far to the left as possible.
2.Using a combination square, check to see if the blade angle is 45° to the table.
3.If the blade is not at 45° to the miter table, tilt the cutting arm to the right, loosen the locknut (5) on the bevel angle adjustment bolt (4) and use a 13 mm wrench to adjust the bolt (4) in or out to increase or decrease the bevel angle.
4.Tilt the cutting arm to the left to 45° bevel and recheck for alignment.
5.Repeat steps 1 through 4 until the blade is at 45° to the miter table.
6.Tighten bevel lock handle and locknut (5) when alignment is achieved.
Fig. Q
1 
4 
5
MOUNTING THE MITER SAW (FIG. R, S)
! WARNING
To avoid injury from unexpected saw movement:
●Before moving the saw, disconnect the power cord from the outlet, and lock the cutting arm in the lower position using the stop latch.
NOTE: The stop latch is for carrying or storing the tool. It is not to be used for holding the saw while cutting. Lower blade and press in stop latch to secure saw for transport or storage.
●Never carry the miter saw by the power cord or by the switch handle. Carrying the tool by the power cord could cause damage to the insulation or wire connections resulting in electric shock or fire.
●To avoid injury from flying debris, do not allow visitors to stand behind the saw.
●Place the saw on a firm, level
●Support the saw on a level work surface.
●Bolt or clamp the saw to its support.
Place the saw in the desired location, either on a work bench or recommended leg set. The base of the saw has four mounting holes (10).
17 
