Craftsman 137.21241 operating instructions Avoid Direct EYE Contact

Mounting instructions

1.For stationary use, place the saw in the desired location, directly on a workbench where there is room for handling and proper support of the workpiece. The base of the saw has four mounting holes. Bolt the base of the miter saw (1) to the work surface (5), using the fastening method as shown in Fig. R.

Fig . R
1.	Miter saw base
2.	Hex head bolt		2
3.	Rubber washer	4	3
4.	Flat washer
5.	Workbench	1
6.	Flat washer
7.	Lockwasher	5
8.	Hex nut
		6
9.	Jam nut		8
	10	7
			9

10

NOTE: Mounting hardware is not included with this tool. Bolts, nuts, washers, and screws must be purchased separately.

2.For portable use, place the saw on a 3/4 in. thick piece of plywood. Bolt the base of the miter saw securely to the plywood using the mounting holes on the base. Use C-clamps to clamp this mounting board to a stable work surface at the worksite.

Fig . S

3/4 Inch Plywood

Hand Hold for

Transportation

THE LASER GUIDE (Fig. T)

1.To turn laser on, turn switch (1) to “I” position.

2.To turn laser off, turn switch to “O” position.

Fig . T

1

Your tool is equipped with the Laser Guide using a Class III laser beam. The laser beam will enable you to preview the saw blade path on the stock to be cut before starting the miter saw. This laser guide is powered by two AAA 1.5 volt batteries.

AVOID DIRECT EYE CONTACT

!WARNING

●Laser is radiated when laser guide is turned on. Avoid direct eye contact. Always un-plug the miter saw from power source before making any adjustments.

●Laser Warning Label:

Max output <5mW DIODE LASER:

630-670nm, Complies with 21CFR 1040.10 and 1040. 11.

!WARNING

●Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

!WARNING

●The use of optical instruments with this product will increase eye hazard.

●Do not attempt to repair or disassemble the laser. If unqualified persons attempt to repair this laser product, serious injury may result. Any repair required on this laser product should be performed by a Sears or other qualified service center.

NOTE: All the adjustments for the operation of this machine have been completed at the factory.

18