INSTALLING THE MITER HANDLE (FIG. B)
1.Thread the miter handle (1) into the hole (2) located at the front of the miter table.
Fig. B
2
1
! WARNING
To avoid injury and damage to the saw, transport or store the miter saw with the cutting head locked in the down position.
Never use the stop latch to hold the cutting head in a down position for cutting operations.
CUTTING HEAD (FIG. C)
Raising the Cutting Head
1.Push down slightly on the switch handle (1).
2.Pull the
3.Pull up the switch handle (1) to raise to the up position.
Fig. C | 1 |
4
5
6
2
3
Locking Cutting Head in Down Position
When transporting or storing the miter saw, the cutting head should always be locked in the down position.
1.Push the switch handle (1) down to its lowest position.
2.Pull the
(6) of the locking hole (3) and turn 90º to insert into the long slot (5).
IMPORTANT: To avoid damage, never carry the miter saw by the switch handle, the cutting arm or the miter handle. ALWAYS use the designated carrying handle (4).
INSTALLING THE DUST BAG (FIG. D)
1.Squeeze the metal collar wings (2) of the dust bag (1).
2.Place the dust bag neck opening around the
exhaust port (3), and release the metal collar wings.
Fig. D
1 2
3
INSTALLING THE EXTENSION WINGS
! WARNING
To avoid injury or possible damage to the tool, support long workpieces by installing the extension wings to extend the work support surface.
To Install the Left/Right Extension Wing (Fig. E)
1.Loosen the extension wing locking screw (1) from the base (3).
2.Place the left extension wing into the holes (2) provided in the miter saw base.
3.Insert the extension wing locking screw back to hole and tighten to hold the extension.
4.Repeat step 1 to 3 to install the right extension wing.
Fig. E
1
2
3
13 
