SET-UP
1.Engine must kill if blades are engaged without O.P. levers held down.
2.Engine must kill if the thumb latches are un- locked without holding O.P. levers down.
3.Engine must not start unless the blades are disengaged and the drive levers are locked in the thumb latches.
4.Do not operate the mower if the interlock safety system allows operation or starting in any un- safe condition.
HANDLE HEIGHT ADJUSTMENT
The height of the handles is adjustable to two po- sitions to accommodate different height operators. The handles are preset from the factory in the high- est position. To adjust the handles to the lower position, remove the top bolt on each side of the handle where it is bolted to the tank support. Tilt the handles down until the next set of holes line up. Reinstall the bolts and nuts and tighten. Check that the bottom bolts are tight as well. Reverse the steps to raise the handles to the higher position.
NOTE: The motion control adjustments will need to be reset after changing the height of the handles. See the Adjustment section on page 9.
REMOVE |
FIGURE 8
11
