OPERATION
BYPASS POSITION
9
DRIVE
POSITION
BRAKE
POSITION
FIGURE 11
3.Blade engagement switch: Located in the middle of the console. To engage the blades pull up on the switch, to disengage the blades push down on the switch.
4.Choke: Located on the left side of the con- sole. Use when starting cold engine do not run choke when engine is warm. Use the throttle to control the engine RPM.
5.Tracking knob: Located under the console towards the front right corner. If the mower will not travel in a straight line on a smooth sur- face, turn the tracking knob the proper direc- tion until it straightens out.
6.Key switch: Located on the console. The key switch must be turned on, blades disengaged, and drive levers locked in the thumb latches before starting.
7.Fuel shut off valve: Located under the tank support in the fuel line.
8.Operator presence levers: Located on the handle. One or both levers must be pressed against the handle for the mower to remain run- ning, when the blades are engaged or neutral lock bail is not locked in drive levers.
9.Brake/Bypass Lever: Located at the back of the rear deck. Used to apply park brake or by- pass/ IZT for free wheel (neutral) condition.
10.Throttle Control: Controls speed of engine
11.Hour Meter: Records the number of hours the unit is operated.
12.Thumb Latches: Locks drive levers in the stop position.
13
