Installation Instructions |
CABLE MANAGEMENT
NOTE: Steps 1 through 6 below apply to models DARKWE110, DARKCE110 and DARKPZ110. Proceed to Step 5 if installing DARKCD110.
1.Attach all cables to display.
2.Open the cable management bracket by sliding it towards the edge of the arm (See Figure 9).
NOTE: If necessary, cable management bracket attach screws may be loosened using hex key.
2 | Attach | 4 | |
Screws | |||
|
| ||
OPEN Position |
| CLOSED Position | |
| View from Bottom | ||
Figure 9
CAUTION: Ensure that adequate cable slack exists for movement of display, and that cables will not be pinched when bracket is closed.
3.Carefully insert cables into bracket (See Figure 10).
CAUTION: Ensure that adequate cable slack exists for movement of display, and that cables will not be pinched by installation of cover (H) or screws (J).
5.Carefully insert cables in cavity located in lower portion of mount arm (See Figure 11).
6.Using Phillips screwdriver, install two covers (H) with four screws (J).
| Cable Path |
| (typical) |
| 5 |
| (H) x2 |
6 | (J) x4 |
Figure 11
3
Cable Management
Bracket (in open position)
Cable Path (typical)
NOTE: Display not shown for clarity.
Figure 10
4.Close cable management bracket by sliding it back towards the center line of the arm (See Figure 9).
NOTE: If necessary, cable management bracket attach screws may be tightened using hex key.
10
