I N S T A L L A T I O N I N S T R U C T I O N S
Medium Flat Panel
Dual Swing Arm Wall Mount (JWD)
Model
The JWD single swing arm wall mount was designed for mounting a medium sized flat panel display. The JWD can swing out from the wall or fold against the wall, depending on your ergonomic need. The mount itself can be tilted +15º. The amount of tilt left and right depends on the size and location of the display.
The JWD is shipped with the VESA® 100mm/100mm Centris™ interface which is compatible with most medium flat panels. To accommodate the mounting hole patterns on existing medium flat panels that are offered in different sizes, the JWD is supplied with two interface adapters, listed below:
•The 200mm/100mm interface adapter
•The interface adapter that accomodates the 400mm/200mm and 550mm/235mm hole patterns
The JWD will more than likely adapt to your medium flat panel display, providing that your display does not exceed the specified weight rating.
BEFORE YOU BEGIN
CAUTION: To prevent damage to the JWD, which could affect or void the Factory warranty, and to the equipment that will be attached to it, thoroughly study all instructions and illustrations before you begin the installation. Pay particular attention to the “Important Warnings and Cautions” on Page 2.
•The maximum weight to be installed on the JWD wall mount is 75 pounds (34 kg).
•The JWD wall mount is designed to be installed using wall studs or supporting framework. The structure to which the JWD wall mount is anchored must be capable of supporting five times the total weight of the mount and all attached equipment.
•If you have any questions about this installation, contact Chief Manufacturing at
•If a defect is discovered after Dell’s initial
CHIEF MANUFACTURING INC. | |
♥2006 Chief Manufacturing | |
8401 EAGLE CREEK PARKWAY, STE 700 | www.chiefmfg.com |
SAVAGE, MINNESOTA 55378 USA | Printed in USA 03/06 |
|
|
