Chief Manufacturing MSS6000 Mount Installation, Display 24 Inches High or Smaller

Installation Instructions MSS6000

INSTALLATION

Mount Installation

Free Standing (not anchored) Applications Only:

NOTE: Do not perform this step if you are going to anchor the stand to a surface.

1.Install five rubber bumpers (B) on bottom of stand. (See Figure 1)

Rubber Bumpers

(5 places)

View from Bottom

Figure 1

Display 24 Inches High or Smaller:

1.Loosen the four height adjustment screws and raise the slide to its maximum height. (See Figure 2)

2.Secure the slide by tightening the four height adjustment screws.

Faceplate Height Adjustment Screws (4)

Figure 2

Display More Than 24 Inches High:

NOTE: The MSS-6000 comes pre-configured for displays 24” in height or less. If a display with a height greater than 24" is being installed follow the instructions below.

To install a display with a height greater than 24":

1.Remove slide plate assembly from the base by removing four 5/16-18 x 3/4" button head cap screws, and four 1/4" flat washers. (See Figure 3)

1	x 4
4	x 4
	x 4
	Base
Slide	Assembly
Plate
Assembly

Figure 3

2.Remove face plate from slide plate assembly by removing two 3/8"-16 x 1" round head carriage bolts, two 1" OD x .563 ID spacers, two 3/8" flat washers, and two 3/8-16 lock nuts. (See Figure 5)

3.Reinstall face plate into upper mounting holes of slide plate using two 3/8"-16 x 1" round head carriage bolts, two 1" OD x .563 ID spacers, two 3/8" flat washers, and two 3/8-16 lock nuts removed in Step 2. (See Figure 5)

4.Reinstall slide plate assembly onto base using four

5/16-18 x 3/4" button head cap screws and four 1/4" flat washers previously removed in Step1. (See Figure 3)

5.Raise slide plate assembly to maximum height.

6.Secure slide plate in place by tightening the four height adjustment screws. (See Figure 2)

	Slide
Face	Plate
Plate	Lock
	Nut
	Flat
	Washer
	Spacer
Carriage Bolt

Figure 4

5