MSS6000 | Installation Instructions |
2 deg. Max.
Roll Adjustment Nuts (2 places)
NOTE: Adjustment nuts located between slide plate and back plate of base assembly.
Figure 9
Display Swivel Tension Adjustment
Display swivel tension is
If swivel tension adjustment is required:
1.Disconnect all cords and cables from display.
2.Follow steps in Removing Display from Mount section.
3.Lay mount on back. (See Figure 10)
4.Locate three tensions adjustment screws. (See Figure 10)
5.Turn each adjustment screw either clockwise to increase tension, or
NOTE: It is important that all adjustment screws are turned equal amounts in the same direction for the display to turn properly.
6.Install display following the instruction outlined in Display Installation section on page 6.
7.Test display swivel tension by grasping each side of display and turning display left and right.
If additional swivel tension adjustment is required, repeat
steps 1 through 7 above.
Display Swivel Stop Location Adjustment
The
To install swivel stops:
1.Follow steps 1 through 3 of Display Swivel Tension Adjustment section.
2.Insert one
Tension Adjustment Screw (Turn left to decrease tension Turn right to increase tension)
Figure 10
35 degrees | 15 degrees |
25 degrees |
|
Figure 11
8