MF1, MF2, PF1, PF2 Series | Installation Instructions |
Using the Stand
CAUTION: This stand is intended for use only with the
products and maximum weights indicated: 125 lbs (56.70 kg) for the MF1, 250 lbs (113.40 kg) for the MF2 [125 lbs
(56.70 kg) per faceplate]; 200 lbs (90.72 kg) for the PF1, 400 lbs (181.44 kg) for the PF2 [200 lbs (90.72 kg) per faceplate]. Use with other products or products heavier than the maximum weights indicated may result in instability causing possible injury.
WARNING: STAND CAN TIP OVER RESULTING IN RISK OF INJURY. Never move the stand when displays are attached. Never push against the stand.
Removing Display(s) from Stand
1.Remove bolt or padlock from faceplate (if used).
NOTE: The pin may have been used as a more permanent locking device. If so, remove nut and pin and move from the lower holes to the upper holes.
2.Pull back on flag on upper mounting hole and press pin down into "Open" position. (See Figure 15)
WARNING: EACH DISPLAY MAY WEIGH IN EXCESS OF 40 LBS! Always use two people and proper lifting techniques when installing or positioning display on stand.
3.Carefully lift display(s) from stand.
4.Lift up on pin and place flag back against faceplate to return it to "Closed" position.
1 | Remove bolt |
|
| or padlock | 2 |
| if used | |
Pin in |
| |
"Closed" |
| |
position - |
| |
move to |
| |
"Open" |
| |
position to |
| |
remove |
| |
display |
| |
| 4 |
|
Pin in |
| |
"Open" |
| |
position - |
| |
move to |
| |
"Closed" |
| |
position |
| |
after display |
| |
is removed. |
|
Figure 15
10