MF1, MF2, PF1, PF2 Series | Installation Instructions |
Attaching Display to Stand
WARNING: EXCEEDING MAXIMUM WEIGHT CAPACITY MAY LEAD TO SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s responsibility to ensure the total amount of weight placed on the stand does not exceed 125 lbs (56.70 kg) for the MF1, 250 lbs (113.40 kg) for the MF2 [125 lbs (56.70 kg) per faceplate]; 200 lbs (90.72 kg) for the PF1, 400 lbs (181.44 kg) for the PF2 [200 lbs (90.72 kg) per faceplate].
CAUTION: Before attaching display(s) to the stand ensure the stand is on level surface.
CAUTION: ALWAYS remove the display(s) BEFORE adjusting the height of the stand.
1.Adjust the stand to the desired height by holding the top part of the post, pulling out knob on the center post and turning 90o in either direction to disengage the locking mechanism. (See Figure 9)
1 | 2 |
Figure 9
2.Raise or lower the center post, then turn the knob 90o either direction to engage the knob and lock the stand at desired height. (See Figure 9)
IMPORTANT ! : Set the height of the stand so the display does NOT rest on the lower part of the post. (See Figure 9) Always set the height so the knob is engaged in a hole in the center post.
3.Attach PSBU or MSBU interface bracket(s) to the display(s) following the instructions included with the bracket.
4.While supporting both sides of display, align four mounting buttons on display or interface bracket with four mounting holes in head assembly. (See Figures 10 and 11)
5 |
Figure 10
WARNING: EACH DISPLAY MAY WEIGH IN EXCESS OF 40 LBS! Always use two people and proper lifting techniques when installing or positioning display on stand.
5.Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly seated in lower area of mounting holes.
(See Figures 10 and 11)
WARNING: IMPROPER INSTALLATION CAN LEAD TO STAND OR DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Ensure mounting buttons are completely engaged in mounting holes.
NOTE: Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See Figure 11)
Remove pin | 4 | |
and nut and | ||
| ||
move to lower holes |
|
5
A padlock or bolt may 
be placed through latch holes
Figure 11
8
