Chrysler 2005 Town and Country manual Using HomeLink Erasing HomeLink Buttons

168 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

successfully been accepted by HomeLink. (The indicator light will flash slowly and then rapidly.) Proceed with Programming step four to complete.

Using HomeLink

To operate, simply press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e. garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.). For convenience, the hand-held transmitter of the device may also be used at any time. In the event that there are still programming difficulties or questions, contact HomeLink at: www.homelink.com or 1-800-355- 3515.

Erasing HomeLink Buttons

To erase programming from the three buttons (individual buttons cannot be erased but can be reprogrammed - note below), follow the step noted:

•Press and hold the two outer HomeLink buttons until the indicator light begins to flash-after 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with Programming - step 2.

Reprogramming a Single HomeLink Button

To program a device to HomeLink using a HomeLink button previously trained, follow these steps:

1.Press and hold the desired HomeLink button. Do NOT release the button.

2.The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink button, proceed with Programming step 2

For questions or comments, contact HomeLink at: www.homelink.com or 1-800-355-3515.