Chrysler 2005 Town and Country manual Sliding Door Open Flash, Power Sliding Door If Equipped

NOTE: The driver’s side sliding door cannot be opened while the fuel door is open. This feature operates only when the sliding door is fully closed prior to opening the fuel door.

Sliding Door Open Flash

When the sliding door(s) are opened, the left and right exterior hazard lights will flash for 12 seconds to alert other drivers in the area that passenger(s) could be entering or exiting the vehicle.

The Sliding Door Open Flash can be enabled or disabled by performing the following procedure:

1.Place the key in the ignition switch.

2.Cycle the ignition switch ON/OFF four times ending in the OFF position. (do not start the engine)

3.Within 10 seconds of the final cycle, press the hazard switch.

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 31

4.A single chime will sound to signify that you have successfully completed the programming.

You can turn the feature back on by repeating the above 2 mentioned procedure or by performing the procedure in the Electronic Vehicle Information Center (EVIC), Cus- tomer Programmable Features section on vehicles so equipped.

Power Sliding Door — If Equipped

NOTE: The power sliding door must be unlocked before the switches located on the trim panel, just in front of the power sliding door will operate.

The power sliding door may be opened manually or by using the buttons on the remote keyless entry transmitter.

Press the buttons on the remote keyless entry transmitter twice within five seconds, to open a power sliding door. Once the door is fully open, pressing the button twice within five seconds a second time will close the door.