A P P E N D I X B

ROM Monitor

This appendix describes the Cisco router ROM monitor (also called the bootstrap program). The ROM monitor firmware runs when the router is powered up or reset. The firmware helps to initialize the processor hardware and boot the operating system software. You can perform certain configuration tasks, such as recovering a lost password or downloading software over the console port, by using the ROM monitor. If there is no Cisco IOS software image loaded on the router, the ROM monitor runs the router.

This appendix contains the following sections:

Entering the ROM Monitor

ROM Monitor Commands

Command Descriptions

Disaster Recovery with TFTP Download

Configuration Register

Console Download

Entering the ROM Monitor

To use the ROM monitor, you must be using a terminal or PC that is connected to the router by means of the console port. Refer to the installation chapter in the Hardware Installation Guide for your router, for information about connecting the router to a PC or terminal.

 

 

Cisco 1700 Series Router Software Configuration Guide

 

 

 

 

 

 

78-5407-03

 

 

B-1

 

 

 

Page 1
Image 1
Cisco Systems 1700 appendix Entering the ROM Monitor