Chapter 2 Installation
Preparing for Installation
Hungary
This equipment is a class A product and should be used and installed properly according to the Hungarian EMC Class A requirements (MSZEN55022). Class A equipment is designed for typical commercial establishments for which special con- ditions of installation and protection distance are used.
Figyelmeztetés a felhasználó i kézikö nyv számára:
Ez a berendezés “A” osztályú termék, felhasználására és ü zembe helyezésére a mag- yar EMC “A” osztályú kö vetelményeknek (MSZ EN 55022) megfeleloen kerü lhet sor, illetve ezen “A” osztályú berendezések csak megfelelo kereskedelmi forrásbó l származhatnak, amelyek biztosítják a megfelelo speciális ü zembe helyezési kö rü lményeket és biztonságos ü zemelési távolságok alkalmazását.
Installation Guidelines
The switch can be installed on a table or shelf, in a rack, or on a wall.
Before installing the switch, first verify that the switch is operational by powering it on and running POST. Follow the procedures in the “Powering On the Switch and Running POST” section on page
Caution There are no serviceable parts inside the unit. Removing screws, cover, or otherwise dismantling the unit voids the warranty.
Warning Unplug the power cord before you work on a system that does not have an on/off switch.
When determining where to place the switch, be sure to observe these guidelines:
•For 10/100 ports, cable lengths from the switch to connected devices are up to 328 feet (100 meters).
•For
|
| Catalyst 2900 Series XL Hardware Installation Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|