Cisco Systems 71 manual Understanding the Phone Startup Process, Purpose, Related Topics

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network

Understanding the Phone Startup Process

Understanding the Phone Startup Process

When connecting to the VoIP network, the Cisco Unified IP Phones 7962G, 7942G, 7961G, 7961G-GE, 7941G, and 7941G-GE go through a standard startup process that is described in Table 2-3. Depending on your specific network configuration, not all of these steps may occur on your Cisco Unified IP Phone.

Table 2-3	Cisco Unified IP Phone Startup Process
Task	Purpose	Related Topics
1.	Obtaining Power from the Switch	• Adding Phones to the Cisco Unified
	If a phone is not using external power, the switch	Communications Manager Database, page 2-8.
	provides in-line power through the Ethernet cable	• Resolving Startup Problems, page 9-1.
	attached to the phone.
2.	Loading the Stored Phone Image	• Resolving Startup Problems, page 9-1.
	The Cisco Unified IP Phone has non-volatile Flash
	memory in which it stores firmware images and
	user-defined preferences. At startup, the phone runs a
	bootstrap loader that loads a phone image stored in
	Flash memory. Using this image, the phone initializes
	its software and hardware.
3.	Configuring VLAN	• Network Configuration Menu, page 4-5.
	If the Cisco Unified IP Phone is connected to a	• Resolving Startup Problems, page 9-1.
	Cisco Catalyst switch, the switch next informs the
	phone of the voice VLAN defined on the switch. The
	phone needs to know its VLAN membership before it
	can proceed with the Dynamic Host Configuration
	Protocol (DHCP) request for an IP address.
4.	Obtaining an IP Address	• Network Configuration Menu, page 4-5.
	If the Cisco Unified IP Phone is using DHCP to obtain	• Resolving Startup Problems, page 9-1.
	an IP address, the phone queries the DHCP server to
	obtain one. If you are not using DHCP in your
	network, you must assign static IP addresses to each
	phone locally.
5.	Accessing a TFTP Server	• Network Configuration Menu, page 4-5.
	In addition to assigning an IP address, the DHCP	• Resolving Startup Problems, page 9-1.
	server directs the Cisco Unified IP Phone to a TFTP
	Server. If the phone has a statically defined IP address,
	you must configure the TFTP server locally on the
	phone; the phone then contacts the TFTP server
	directly.
	Note You can also assign an alternative TFTP server
	to use instead of the one assigned by DHCP.

Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 7.1

OL-18913-01 2-7