
1-4
Clear Channel 6-Port T3 (DS3) Line Card Installation and Configuration
OL-3449-02
Chapter 1 Overview
T3 SMB Cables
The following conditions must all be met before the 6T3 line card is enabled:
•The 6T3 line card is correctly connected and receiving power.
•The Network Services Engine 100 (NSE-100) recognizes the 6T3 line card .
•The Cisco IOS image on the NSE-100 is running.
If any one of these conditions is not met, or if the initialization fails, the STATUS LED does not go on.
Tabl e 1-2 lists 6T3 line card LED colors and indications.
T3 SMB CablesThe cables used to connect the 6T3 line card are presented in the following sections:
•Ordering Cables, page 1-6
•Building Your Own Cables, page 1-6
We recommend using six T3 SMB cables. The cables are 10 feet (3.048 meters) long and have two
female SMB connectors on one end, and two female or ma le bayonet coupling (BNC) connectors on the
other end. Use the female SMB cable connectors to connect the local line card RX and TX ports. Use
the BNC cable connectors to connect the line card RX and TX ports to other devices. See Figure 3-2.
Note Cisco does not automatically provide the six T3 SMB cables recommended for your 6T3
line card.
Table1-2 6T3 Line Card LE Ds
LED Label Color State Meaning
OIR Green On Line card is ready to be removed in
CLI-controlled OIR.
Off Line card is online.
STATUS Green/Yellow Green Indicates line card is online.
Yellow Indicates line card bootstrappin g is in progre ss.
Off Indicates line card is offline or deactivated.
LNK Green/Yellow Green Line card port is enabled.
Yellow Line card port is in l oo pbac k m ode or is rec eiving
or transmitting alarms.
Off Line card port is disabled.