
4-13
Clear Channel 6-Port T3 (DS3) Line Card Installation and Configuration
OL-3449-02
Chapter4 Configuring the 6T3 Line Card Checking the Configuration
Using the show interfaces CommandThe show interfaces command displays status information (including the physical slot and in ter face
address) for the interfaces you specify. The example that follows specifies serial interfaces.
Note The outputs that appear in this docum ent m ay no t mat ch t h e out pu t yo u rece ive when r unn ing th ese
commands. The outputs in this document are exam ple s o nly.
Cisco 7304 Routers
Following is an example of the show interfaces command for Cisco 7304 routers. In t his exam pl e, t h e
serial interfaces (0 to 5) are on a 6T3 line card in slot 5; also, the status information for interfaces 1
through 5 is omitted. (Interfaces are administratively shut down until you enable them.)
Router# show interfaces serial 5/0
Serial5/0 is up, line protocol is up
Hardware is Packet over DS3
Internet address is 50.1.1.2/8
MTU 9216 bytes, BW 44210 Kbit, DLY 200 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive not set
Scramble enabled
Last input 15:00:13, output 15:00:13, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue :0/40 (size/max)
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
5 packets input, 520 bytes, 0 no buffer
Received 0 broadcasts, 101 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun,, 42 abort
5 packets output, 520 bytes, 0 underruns
0 output errors, 0 applique, 4 interface resets
0 output buffer failures, 0 output buffers swapped out
4 carrier transitions
[Additional display text omitted from this example]