1-13
Cisco 8500 Series Wireless Controller Installation Guide
Chapter 1 Cisco 8500 Series Wireless Controller Installation Guide
Mounting the Cisco 8500 Series Wireless Controller in a Rack
Note Use cage bars with square-holed racks, clip nuts with round-holed racks, and your own screws or the
screws provided in this kit with threaded-hole racks.
Note If the slide rails in your rack installation kit came with shipping thumbscrews, remove them before you
begin the following installation procedure.
Step 1 Select an available 1U space in your rack to install your controller. If you have either a round-holed or
square-holed rack, install cage bars or clip nuts in the middle and the bottom (optional for the upper)
holes of the lower U on each side of the front of the rack. Then, install cage bars or clip nuts in the upper
and the bottom holes of the lower U on each side of the rear of the rack.
M6 screws
(12)
Cage bars
(4)
Slide rail
(right)
Slide rail
(left)
Front of rails
10-32 screws
(13)
12-24 screws
(13)
EIA latches
(2)
Clip nuts
(13)
255172