Installation Instructions
Figure 6 | Mounting the Antenna on a Wall |
2 3
5
4
1
3
135159
1 | Wall anchors | 2 | Molded wall mount |
|
|
|
|
3 | 4 | Articulating arm | |
|
|
|
|
5 | Molded antenna mount |
|
|
|
|
|
|
To mount the antenna on a wall, follow these steps:
Step 1 Choose a location for mounting.
Step 2 If an extension coaxial cable is used, connect it to the access point and extend the coaxial cable to the location for mounting the antenna.
Step 3 Attach the antenna to the molded antenna mount using the four provided
Step 4 Attach the antenna mount to the articulating arm (all mounting hardware is provided):
a.Place a
b.Insert the screw and washers, first through the molded antenna mount, then the articulating arm.
c.Secure the articulating arm to the molded antenna mount using a
Step 5 Find the molded wall mount and position it on the mounting surface. Use a pencil to mark the location of the mounting holes. There are four holes for
Step 6 Using a
Step 7 Route the cable either up or down from the wall or corner.
Step 8 Install a wall anchor in each hole.
Step 9 Line up the mounting holes on the molded wall mount with the pilot holes and start one of the provided
Step 10 Tighten the screws with a Philips screwdriver.
Step 11 Attach the articulating arm to the molded wall mount (all hardware is provided):
a.Place a
b.Insert the screw and washers, first through the molded wall mount, then the articulating arm.
c.Secure the articulating arm to the molded wall mount using a
Cisco Multiband
| 11 |
| |
|
|