Cisco Systems AS5800 manual Configure clock priority, which is a value from 1 to

Chapter 3 Channelized T3 Trunk Card

Configuring the CT3 Trunk Card

Table 3-3 T3 Configuration Commands (continued)

	Command	Description
Step 13
	AS5800(config)# dial-tdm-clock priority	Configure clock priority, which is a value from 1 to 50.
	{1-50} {external trunk-slot}{0-5}	Select a clocking source by selecting an external
	ds3-port 0 port {1-28}
		reference clock or a trunk card. If you are using an
		external reference clock, no other CLI is needed. If you
		are using a trunk card, select a dial shelf slot from
		0 to 5.
		Select the T3 port number, which has a value of 0.
Step 14
	AS5800# copy running-config	Save your changes when ready.
	startup-config

1. To deactivate a command functionality, type no before the command.

To verify your software configuration, you can enter show commands to display clock (show dial-shelf clock) and controller (show controller t3) settings. To enter show commands, you must be in privileged EXEC mode. Some examples:

AS5800#		show dial-shelf clock
Primary		Clock:
--------------
Slot 12:
System primary			is 1/1/0:2 of priority 213
TDM Bus		Master	Clock Generator State = NORMAL
Backup clocks:
Source		Slot	Port DS3-Port Priority								Status		State
-------------------------------------------------------------
Trunk		0	1			0			206		Bad		Default
Trunk		0	2			0			212		Bad		Default
Trunk		1	4			0			225		Good		Default
Status of trunk clocks:
-----------------------
	Ds3			2	2	2	2 2 2	2	2 2 1 1	1	1 1 1 1	1	1 1
Slot	Port Type			8 7 6			5 4 3 2 1 0 9 8 7 6 5 4 3 2 1 0 9 8 7 6 5 4 3 2 1
0	0	T3		G G G G G G G G G G G G G G G G G G G G G G G G G G G G
1	0	T3		B B B B B B B B B B B B B B B B B B B B G G G G G G G G

Cisco AS5800 Universal Access Server Dial Shelf Card Guide

3-14 78-7097-03