3-4
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-01
Chapter3 Prep aring Your Site for Installation
Standard Warning Statements
Warning
To comply with the Class A emissions requirements of EN55022 and CISPR22- shielded twisted pair
T1/E1 cables must be used for SPA-8-Port Channelized T1/E1 SPA (SPA-8XCHT1/E1).
EN55022/CISPR22
Statement
Warning
To comply with the FCC Class A emissions requirements- shielded twisted pair T1/E1 cables must be
used with SPA-8-Port Channelized T1/E1 SPA (SPA-8XCHT1/E1).
EN55022/CISPR22 Statement
Warning
Power cable and AC adapter - When installing the product, please use the provided or designated
connection cables/power cables/AC adaptors. Using any other cables or adapters could cause a
malfunction or a fire. Electrical Appliance and Material Safety Law prohibits the use of certified
cables (that have the ‘UL’ shown on the code) for any other electrical devices than products
designated by Cisco. The use of cables that are certified by Electrical Appliance and Material Safety
Law (that have ‘PSE’ shown on the code) is not limited to Cisco-designated products.
Statement 371
Warning
Only trained and qualified personnel should be allowed to install or replace this equipment
Statement 1030
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than: AC power supplies for the Cisco ASR 1004 Router, Cisco
ASR 1006 Router, and Cisco ASR 1002 Router: 120 VAC, 20A U.S. maximum. DC power supplies for the
Cisco ASR 1004 Router: 40A U.S. maximum. DC power supplies for the Cisco ASR 1006 Router: 50A U.S.
maximum. DC power supplies for the ASR 1002 Router: 30A U.S. maximum..
Statement 1005
Warning
This product requires short-circuit (overcurrent) protection to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations.
Statement 1045
Warning
This unit may have more than one power supply connection. All connections must be removed to
de-energize the unit.
Statement 1028
Warning
The plug-socket combination must be accessible at all times, because it serves as the main
disconnecting device.
Statement 1019
Warning
Hazardous voltage or energy may be present on the DC power terminals. Always replace cover when
terminals are not in service. Be sure uninsulated conductors are not accessible when cover is in
place.
Statement 1075
Warning
Use copper conductors only.
Statement 1025