Cisco Systems CISCO881SECK9 manual Configuring Adsl Auto Mode, Configuring CPE and Peer Adsl Mode

Chapter 3 Basic Router Configuration

Configuring WAN Interfaces

•Verifying CPE to Peer Connection for ADSL

Configuring ADSL Auto Mode

Perform these steps to configure the DSL controller to auto mode, starting in global configuration mode.

Note Configure the DSLAM in ADSL 1/2//2+ mode prior to configuring the router.

SUMMARY STEPS

1.controller vdsl slot

2.operating mode {autoadsl1adsl2adsl2+vdsl2ansl}

3.end

DETAILED STEPS

	Command	Purpose
Step 1	controller vdsl slot	Enters config mode for the VDSL
	Example:	controller.
	Router (config) #
	Controller vdsl 0
Step 2	operating mode	Configures the operating mode. The
	{autoadsl1adsl2adsl2+vdsl2	default is auto and is recommended.
	ansl}
	Example:
	Router (config-controller) #
	operating mode
	auto
Step 3	end	Exits the configuration mode and enters
	Example:	EXEC mode.
	Router (config-conroller) #
	end
	Router

When configured in auto, the operating mode does not appear in the show running command.

Configuring CPE and Peer ADSL Mode

When configuring for ADSL, the ATM main interface or ATM sub-interface must be configured with a PVC and an IP address, perform a no shutdown command on the interface if needed.

	Cisco 880 Series Integrated Services Router Software Configuration Guide
OL-22206-01		3-11