Note: For safety, periodically check the resistance value of the antistatic strap. The measurement should be within the range of 1 and 10 Mohms.
Installation
The following installation process describes the procedure for shutting down the interfaces on which you will replace connector locks, removing the
Note: Although shutting down an interface before replacing the lock is not required, Cisco Systems recommends that you do so as a precaution to protect the electronic components in the system and to avoid creating problems on your network.
Shutting Down Interfaces
It is unlikely that interface ports will be enabled if you have not been able to connect the network interface cables. However, if any of the interfaces are already enabled, you can avoid potential problems by administratively shutting the interface down and, when the replacement is complete, enabling the interface again with commands you enter from the console terminal.
The shutdown interface subcommand disables all functions and prevents all packet transmission on the interface that you specify with the interface type slot/port command. The no shutdown interface subcommand turns the interface back on. Because interface is a
Following is an example session to first enter the privileged level and configuration mode, and then to specify and shut down each of the first two Ethernet ports (port 0 and port 1) on an EIP installed in slot 1 of the Cisco 7000. Entering
Router>enable
Password:secretword
Router#configure
Configuring from terminal, memory, or network [terminal]?
interface ethernet 1/0 shutdown
interface ethernet 1/1 shutdown
^Z
6Jackscrew Installation Instructions (for EIP Ports)
