![](/images/new-backgrounds/1142340/14234045x1.webp)
Replacing the Line Card in the Cisco
Note It is not necessary to configure the cable interface line card if you are installing a replacement card in the identical slot. The system automatically downloads the necessary configuration information from the process routing enigne (PRE).
Step 1 Connect all downstream and upstream coaxial cables to the cable interface line card, as necessary.
Step 2 Configure the cable interface line card, if necessary. For information about configuring the cable interface line card, refer to the Cisco uBR10012 Universal Broadband Router Software Configuration Guide at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/cable/index.htm
Replacing the Line Card in the Cisco uBR10-LCP2 Adapter Card
The following section describes how to remove and replace a Cisco
Note Do not attempt to separate or remove the cable interface line card from the Cisco
Tip To prevent alarms from activating, you must administratively shut down a cable interface line card before hot swapping it. Refer to “Shutting Down and Restarting the Interface” in the Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/inter_c/icdoverv.htm
Refer to the release notes at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/cable/ubr10k/ub10krns/index.htm.
Otherwise, inform the network administrator that this portion of the network will be temporarily interrupted. If the maintenance LED is on, you can remove the cable interface line card without affecting systems operations.
Removing the Cable Interface Line Card from the Adapter Card
Note The Cisco
Step 1 Ensure that you are properly grounded before handling the line card.
Cisco
| 23 |
| |
|
|