Send document comments to nexus3k-docfeedback@cisco.com
1-5
Cisco Nexus 3000 Series Hardware Installation Guide
OL-25338-04
Chapter 1 Overview of the Cisco Nexus 3000 Series Switches
Cisco Nexus 3016 Switch
Fan Tray for the Cisco Nexus 3016 Switch
The Cisco Nexus 3016 switch ships with one fan tray, which is the same fan tray used by the Cisco Nexus
3064 switch (part number N3K-C3064-FAN for forward airflow or N3K-C3064-FAN-B for reverse
airflow). You can hot swap the fan tray during operations but must replace it within two minutes or the
switch can reach an overtemperature condition and shut down.
Caution You can order a replacement fan tray with forward airflow or reverse airflow. Be sure to order the same
direction of airflow as is used with the switch. If there is a black stripe across the front of the fan trays
and power supplies, the switch is running reverse airflow and you must order a fan tray with reverse
airflow. If there is no black stripe across the front of these modules, the switch has forward airflow and
you must order replacement modules with forward airflow.
Caution The switch must run with all of its power supply and fan tray modules taking in air from a cold aisle and
exhausting air to the hot aisle. If they take in air from a hot aisle, an overtemperature condition can occur
and the switch will shut down. If the airflow directions are mixed in the same switch, you will see an
error.
Port Connections for the Cisco Nexus 3016 Switch
You use QSFP+ transceivers with the 16 networking ports used for uplinking and downlinking. For
low-cost connections to switches in the same or adjacent racks, use QSFP+ transceivers with copper
cables. For long distance connections, use the QSFP transceivers connected to optical cables.
Table 1-3 describes the QSFP+ transceivers and cable connections that you can use with the 16 ports
used for uplinks and downlinks.
Tab l e 1-3 QSFP+ Transceivers and Cables Used with the Cisco Nexus 3016 Switch Uplink and
Downlink Ports
Part Number Transceivers and Cables
QSFP-40G-SR4 40-Gigabit SR4 QSFP transceiver on both ends of an optical cable. Used for
distances up to 100 meters.
QSFP-H40G-CU1M 40-Gigabit transceiver with a 1-meter passive copper cable
QSFP-H40G-CU3M 40-Gigabit transceiver with a 3-meter passive copper cable
QSFP-H40G-CU5M 40-Gigabit transceiver with a 5-meter passive copper cable
QSFP-4SFP10G-CU1M 40-Gigabit transceiver connected to four 1-meter passive copper cables, each
connected to an SFP+ transceiver
QSFP-4SFP10G-CU3M 40-Gigabit transceiver connected to four 3-meter passive copper cables, each
connected to an SFP+ transceiver
QSFP-4SFP10G-CU5M 40-Gigabit transceiver connected to four 5-meter passive copper cables, each
connected to an SFP+ transceiver