Send document comments to nexus3k-docfeedback@cisco.com
3-6
Cisco Nexus 3000 Series Hardware Installation Guide
OL-25338-04
Chapter 3 Connecting to the Network
Connecting to a Server
Installing an Optical Cable into an SFP or SFP+ Transceiver
Caution To prevent possible damage to the cable or transceiver, install the transceiver in the port before installing
the cable in the transceiver.
To install an optical cable into a transceiver, follow these steps:
Step 1 Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 2 Remove the dust cover from the connector on the cable.
Step 3 Remove the dust cover from the cable end of the transceiver.
Step 4 Align the cable connector with the transceiver and insert the connector into the transceiver until it clicks
into place.
Caution If the cable does not install easily, ensure that it is correctly positioned before continuing.
For instructions on verifying connectivity, see the appropriate Cisco Nexus 3000 Series CLI
configuration guide.
Replacing an Optical Cable for an SFP or SFP+ Transceiver
Caution When pulling an optical cable from a transceiver, grip the body of the connector. Do not pull on the
jacket sleeve, because this action can compromise the fiber-optic termination in the connector.
Caution If the cable does not remove easily, ensure that any latch present on the cable has been released before
continuing.
To remove the cable, follow these steps:
Step 1 Attach an ESD-preventive wrist strap and follow its instructions for use.
Step 2 Press the release latch on the cable, grasp the connector near the connection point, and gently pull the
connector from the transceiver.
Step 3 Either install a replacement cable in the SFP or SFP+ transceiver (see the “Installing an Optical Cable
into an SFP or SFP+ Transceiver” section on page 3-6) or insert dust plugs into the cable end of the
transceiver and the end of the removed cable.