Chapter 6 Configuring the Cisco
Working with Service Element Profiles
Table
Attribute | Description | Acceptable Values | Default Value |
|
|
|
|
Training Mode | The training mode for the physical | Standard, Fast | Standard |
| port. In standard mode, the modem | Train |
|
| attempts to train using the method |
|
|
| specified by T1.413 Issue 2. |
|
|
| FastTrain mode is a proprietary, |
|
|
| optimized training algorithm that |
|
|
| works only if both the near and far |
|
|
| end modems are based on mutually |
|
|
| compatible chipsets. If this is not |
|
|
| the case, training results are |
|
|
| unpredictable. The value of this |
|
|
| attribute will apply to both |
|
|
| upstream and downstream |
|
|
| directions. |
|
|
|
|
|
|
G.lite Mode | This attribute is only applicable to | Enabled, Disabled | Disabled |
| 4 port FLEX cards. G.lite mode is |
|
|
| enabled on a per board basis so all |
|
|
| ports in the same board should |
|
|
| have the same value for this |
|
|
| attribute. If Enabled is selected, the |
|
|
| modem that the subscriber is |
|
|
| connected to will run in G.lite |
|
|
| mode. The board should be reset |
|
|
| after enabling this attribute. |
|
|
| Enabling this object will reset the |
|
|
| following attributes to their default |
|
|
| values; Interleaved Delay, |
|
|
| Overhead Frame, Incoming |
|
|
| Bandwidth and Outgoing |
|
|
| Bandwidth. |
|
|
|
|
|
|
Overhead Frame | The overhead framing structure | ReducedMerged | Reduced |
| requested for the modem that the | Fast, Reduced | MergedFast |
| subscriber is connected to. If the | SeparateFast, |
|
| far end modem does not support | FullAsynch.,Full |
|
| this structure, the near end will fall | Synch |
|
| back to the highest number that the |
|
|
| far end supports. The same framing |
|
|
| structure must be used in both |
|
|
| directions. |
|
|
|
|
|
|
Cisco Provisioning Center User’s Guide
|
| |
|