Administration
Time Set ti ngs
Cisco Small Business SG200 Series 8-port Smart Switch 48
3
-Server Kiss of Death—SNTP server has replied with a kiss of death
packet, instructing the switch to stop sending requests to the server, due
to traffic spikes or other error conditions.
-Other—The status could not be determined.
•Last Response—Time of the last response from the SNTP server.
•Versio n—SNTP protocol version the server uses.
•Port—Protocol port number (123 is a well-known port number for SNTP).
•Polling Mode—Whether the switch is configured to send SNTP requests to
this server (Enabled or Disabled).
•Tot al Uni ca st Re qu es ts —The total number of synchronization requests the
switch has made to the unicast server.
To edit the settings for a server, check the box to select it, and then click Edit. To
remove a server, check the box to select it, and then click Delete. To add a new
server, click Add, and then enter the settings, as described below.
To add an SNTP server:
STEP 1 Click Add.
STEP 2 Enter the parameters:
•SNTP Server—Enter an IPv4 address or a domain name. To use a domain
name, ensure that the DNS service is enabled on the switch (see Domain
Name System).
•Authentication Key—Select Enable if authentication is needed when
communicating with the SNTP server.
•Authentication Key ID—If authentication is used, select the Authentication
Key ID from the list. See Configuring SNTP Authentication for in formatio n
on configuring authentication keys.
•Polling Mode—Select Enable to allow the switch to send requests to this
server.