Cisco Systems SPA2102 manual Before You Begin, Connect the Phone Adapter, D E G, Setup tab, Dhcp

Package Contents

•Phone Adapter with Router

•5 V Power Adapter

•RJ-45 Ethernet Cable

•RJ-11 Phone Cable (not included with all models)

•Power Adapter

•Quick Installation

Phone Adapter with Router

Quick Installation

Voice

Model No. SPA2102

Before You Begin

Make sure you have the following:

•An active Internet connection

•An active Internet phone service account and its settings

•A cable/DSL modem

•One computer for configuration of the Phone Adapter

•An analog telephone or fax machine with an RJ-11 phone cable

1		Connect the Phone Adapter
A
	Power off your network
	devices, including your
	modem and PC.
B	Connect one end of an
	RJ-11 phone cable to the
	Phone Adapter’s PHONE 1
	port. Connect the other end
	to your analog telephone or
	fax machine.		B

IMPORTANT: Do not connect the PHONE port to a telephone wall jack. Make sure you only connect a telephone or fax machine to the PHONE port. Otherwise, the Phone Adapter or the telephone wiring in your home or office may be damaged.

C Repeat Step B with the PHONE 2 port if you have an additional telephone or fax machine to connect.

D Connect one end of an Ethernet network cable (included) to the ETHERNET port of the Phone Adapter. Connect the other end to the Ethernet port of your PC.

E Connect one end of a different Ethernet network cable to the INTERNET port of the Phone Adapter. Connect the other end to your cable/DSL modem.

F Power on the cable/DSL modem.

G Connect the included power adapter to the Phone Adapter’s power port, and then plug the power adapter into an electrical outlet. The power LED on the front panel will light up as soon as the Phone Adapter powers on.

H Power on your PC.

D

E

G

NOTE: Make sure your PC’s Ethernet adapter is set to obtain an IP address automatically. For more information, refer to Windows Help.

2		Configure the Phone Adapter
A	Launch the web browser on
	the PC.
B	Enter http://192.168.0.1/
	advanced in the Address
	field (192.168.0.1 is the
	default local IP address of
	the Phone Adapter). Then
	press the Enter key.
C	If your Internet Telephony
	Service Provider (ITSP) did
	not supply a password, you
	will not see a login screen.
	Proceed to step D.
	If your ITSP supplied a
	password, you will see a
	login screen. In the User
	Name field, enter user, the
	default user name for user
	access (this cannot be		C
	changed). Then enter the
	password supplied by your
	ITSP.
D	The Router - Status screen
	will appear. Click the WAN
	Setup tab.

D

E Proceed to the appropriate instructions for your Internet Connection Type: DHCP, Static IP, or PPPoE.

DHCP

1Select DHCP for the Connection Type.

2If you use a cable modem, you may need to configure the MAC Clone Settings.

(Contact your ISP for more information.)

Enable MAC Clone Service. If your service uses a specific PC MAC address, then select yes from the Enable MAC Clone Service setting. Then enter the PC’s MAC address in the Cloned MAC Address field.

3Click Submit All Changes.

Static IP

1Select Static IP for the Connection Type.

2In the Static IP Settings section, enter the IP address in the Static IP field, the subnet mask in the NetMask field, and the default gateway IP address in the Gateway field.

E

MAC Clone Settings

Static IP