...
...
...
1d11h
1d11h
1d11h

State: Steady

4d06h :RS232 event: RTS, DTR, CTS, DCD 4d06h :Static event:

Connect Protocol: ISDN Mode

Compression: None

Connected Standard: V.110

TX,RX Symbol Rate: 0, 0

TX,RX Carrier Frequency: 0, 0

TX,RX Trellis Coding: (n/a), (n/a)

Frequency Offset: 0 Hz

Round Trip Delay: 2 msecs

TX,RX Bit Rate: 19200, 19200

Robbed Bit Signalling (RBS) pattern: 0

Digital Pad: (n/a), Digital Pad Compensation: None 4d06h :Dynamic event:

Sq Value: 7

Signal Noise Ratio: 0 dB

Receive Level: 0 dBm

Phase Jitter Frequency: 0 Hz

Phase Jitter Level: 0 degrees

Far End Echo Level: 0 dBm

Phase Roll: 0 degrees

Total Retrains: 0

EC Retransmission Count: 0

Characters transmitted, received: 0, 0

Characters received BAD: 0

PPP/SLIP packets transmitted, received: 0, 0

PPP/SLIP packets received (BAD/ABORTED): 0

EC packets transmitted, received OK: 0, 0

EC packets (Received BAD/ABORTED): 0

V110 frames received bad: 0

V110 frames received good: 51

V110 frames transmitted: 64

V110 sync lost: 0

:Modem State event: State: Terminate

:RS232 event: RTS, DTR, CTS, noDCD :Modem State event:

State: Idle 1d11h :End Connect event:

Call Timer: 87 secs

Disconnect Reason Info: (0xDF06)

Type (=6 ): Tx (host to line) data flushing - OK Class (=31): Requested by host

Reason (=6 ): network indicated disconnect Total Retrains: 0

EC Retransmission Count: 0

Characters transmitted, received: 308, 50042

Characters received BAD: 0

PPP/SLIP packets transmitted, received: 10, 43

PPP/SLIP packets received (BAD/ABORTED): 0

EC packets transmitted, received OK: 0, 0

EC packets (Received BAD/ABORTED): 0

V110 frames received bad: 3

V110 frames received good: 34493

V110 frames transmitted: 34710

V110 sync lost: 1

...

...

...

10:37:18:Static event:

Connect Protocol: ISDN Mode

8Cisco IOS Release 12.0(4)XI1

Page 8
Image 8
Cisco Systems V110 manual Modem State event State Terminate