Related Documentation
To understand the Cisco IOS
To understand the Catalyst operating system
Unless your switch is located in a fully trusted environment, we recommend that you configure the module through a Telnet connection using Secure Shell (SSH) encryption.
You can session into the module from the switch console to configure the CSM. The session is a Telnet interface through the Ethernet
You can also make a Telnet connection into the module from a specified host and on a specific interface. Telnet support for this host should be configured or enabled from the module console.
Console output is redirected to all active Telnet sessions. When no Telnet session is available, the output is saved to a buffer. The buffer output can be subsequently examined when you make a Telnet connection into the module.
Related Documentation
Use this document with the following Cisco documents:
•Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide
•Catalyst 6500 Series Switch Software Configuration Guide
•Catalyst 6500 Series Switch Content Switching Module Command Reference Release 4.1
•Catalyst 6500 Series Switch Content Switching Module Installation Guide Release 4.1
•Catalyst 6500 Series Switch Content Switching Module and Installation and Configuration Guide Release 4.1
•Release Notes for the Catalyst 6500 Series Switch Content Switching Module Release 4.1.
Translated Safety Warnings
Warning Invisible laser radiation present. Statement 1016
Waarschuwing Onzichtbare laserstraling aanwezig.
Varoitus Näkymättömiä lasersäteitä.
Attention Rayonnement laser actif mais invisible.
Warnung Unsichtbare Laserstrahlung.
Avvertenza Radiazione laser invisibile.
Catalyst 6500 Series Switch Content Switching Module Installation Note
| 21 |
| |
|
|
