Installing the CSM
Figure 5 Positioning the Module in a Vertical Slot Chassis
Ejector lever fully extended
FAN
STATUS
o
o
INPUT | FAN | OUTPUT |
OK | OK | FAIL |
INPUT | FAN | OUTPUT |
OK | OK | FAIL |
SWITCHFABRIC | |
MDL |
|
| S |
| TA |
| TUS |
| A |
| CT |
| IVE |
EMI
gasket
EMI
gasket
63585
Insert module between slot guides
6
4
3
b.Carefully slide the supervisor engine or module into the slot until the EMI gasket along the right edge of the module makes contact with the module in the slot adjacent to it and both ejector levers have closed to approximately 45 degrees with respect to the module faceplate. (See Figure 6.)
c.Using the thumb and forefinger of each hand, grasp the two ejector levers and exert a slight pressure to the left, deflecting the module approximately 0.040 inches (1 mm) to create a small gap between the modules EMI gasket and the module adjacent to it. (See Figure 6.)
Catalyst 6500 Series Switch Content Switching Module Installation Note
18 |
| |
|
