20614 Cisco Installing and Maintaining Routers Part 4: 12000 GSR Series and XS5032 Modules
Router Card: Installing
∙Connect the switch to a computer or other data terminal equipment (DTE) device.
∙Connect the EIA−232 cable to the console, the DB−9 connector, on the switch.
∙Use the console configuration default settings for communication with the switch.
∙Power up the switch.
∙At the Greeting screen, press Return to enter the switch Main menu.
∙Press Ctrl and R from the switch Main menu to access the router card command−line interface (CLI).
Router Card: Configuring
∙Connect an auxiliary terminal to the auxiliary port on your switch.
∙Turn on the power switch.
∙The switch Greeting screen appears. To access the router card from the Main menu, you press Ctrl and R.
∙Select Configuration from the Main menu.
∙Select Router Configuration from the Configuration menu.
∙Enter the box and port numbers and press the Enter key.
∙Select the required option from the Router Configuration menu.
Catalyst 5000 RSM: Installation
RSM: Installing
∙Connect an ASCII terminal to a computer running terminal emulation software to the console port on the Catalyst switch.
∙Use a screwdriver to loosen the captive installation screws and remove the module filler plate or the existing module from the slot that you want to use.
∙Guide the RSM into the slot, aligning the sides of the RSM with the guides in the slot.
∙While keeping the module oriented horizontally, carefully slide it into the slot until its front panel makes contact with the ejector levers.
∙Simultaneously push the left lever and the right lever in to fully seat the module in the backplane connector.
∙Tighten the captive installation screws on the left and right sides of the module.
∙Check the status of the module.
∙After verifying that the RSM is operational, enter the session mod/num command at the Cat5k>prompt.
Glossary
Alphabetical List of Terms
(DTE) Data Terminal Equipment
7