Citizen JNOXXX instruction manual Using the Timer, Convenient Functions, Zero positioning

Using the Timer

This page should be read with the watch diagram, on the first page of this manual, showing the location of the parts.

The timer can be set from 1 to 60 minutes in increments of 1 minute.

[Preparation for using the timer]

1.Press the
M (MODE) button to move the mode hand to [TMR].

2.Pull the
M (MODE) button out to the setting position.

3.Use the
C (SET) button to set the time for the timer.

4.Push the
M (MODE) button in to its normal position. Now timer setting is completed.

[Using the timer - 1]

1.Pressing the
A (START) button starts the countdown. (When the set time has expired (time up), the watch beeps for 5 seconds.)

2.Pressing the
A (STOP) button stops the countdown.

3.Pressing the
C (RESET) button resets the timer

back to the set time.

[Using the timer - 2]

1.Pressing the
M (MODE) button starts the countdown.

2.Pressing the
C button resets the timer back to the set time and restarts the countdown again. (This function is useful in restarting the countdown quickly.)

3.Pressing the
A (STOP) button stops the countdown.

4.Pressing the
C (RESET) button resets the timer back to the set time.

Convenient Functions

This page should be read with the watch diagram, on the first page of this manual, showing the location of the parts.

When the hands of the analog section cover the digital section, making the time in digital difficult to read, utilise the – Hand-retractor function:

Use this function to retract the hour and minute hands of the analog section to the 12 o’clock position.

[Operation]

Hold the
B button down for 2 seconds and then release it when “H.R” blinks in [10].

*During Hand-Retractor mode the minute hand of the UTC time at [3] goes back and forth by 1 minute (-1 minute   +1 minute), and “H.R” displayed at [10] blinks.

[Cancelling Hand-Retractor mode] Pressing the
B button again cancels Hand- Retractor mode.

(H.R.: Abbreviation of Hand-Retractor)

When the watch displays something improperly and a malfunction is suspected, perform –

ALL RESET and zero positioning:

When the watch displays something improperly and a malfunction is suspected, perform ALL RESET and zero positioning, then readjust the time, calendar and other modes.

[ALL RESET]

This function can be operated from any mode.

1.Pull the
M (MODE) button out to the setting position.

2.Hold down the
A ,
B and
C buttons simultaneously for more than 2 seconds then release them.

(All digital segments will light up. Immediately reset to the zero position.)

[Zero positioning]

1.Pressing the
B button resets all segments in the digital section to zeros.

2.The digital display changes in the sequence of UTC ➡ HR ➡ MIN each time the
B button is pressed.

UTC: For zero positioning of the UTC time display

HR: For zero positioning of the hour hand and 24-hour hand

MIN: For zero positioning of the minute hand.

3.Pressing the
A (UP) button turns each hand clockwise. Pressing the
C (DOWN) button turns each hand counterclockwise. Align all hands to the 12 o’clock position.

4.When the
M (MODE) button is pushed in to its normal position, the watch beeps and at the same time the hands start moving. ALL RESET and zero positioning are now completed.

5.Set the time, calendar and other modes.