Citizen Systems CT-S2000DCL Adjusting the Sensitivity of Paper Sensor, Select Paper Type

2Select Paper Type.

Press the FEED button to match the paper type loaded to the LED indications in the table below. (Refer to the table below.)

	POWER LED	ERROR LED
Label	Green lit	(OFF)
Thermal paper roll	(OFF)	Red lit
Black mark paper	Green lit	Red lit

3Save the selected Paper Type to the Printer.

Open and close the printer cover. By this operation, selected paper type is stored in the printer memory and the Selecting Paper Type mode is terminated.

Since then, "P.Length Set" of Memory switch 4-1 becomes disable.

When closing the printer cover during the setting a black mark paper or label paper in the printer, paper length is measured, and the result will be printed out.

*When paper detection error occurs at the measurement of paper length, automatically enters paper sensor adjustment mode. Adjust the sensor in accordance with “5.5 Adjusting the Sensitivity of Paper Sensor”.

5.5 Adjusting the Sensitivity of Paper Sensor

Before using black mark paper (BM paper) or label paper, adjust the sensitivity of the paper sensor by using actual paper.

1Enter Adjusting Paper Sensor mode.

Open the printer cover, remove paper, and then set the printer power switch to ON. Here, POWER LED and ERROR LED go on with the buzzer sound. Then close the printer cover while pressing the FEED button. The ERROR LED starts blinking with the buzzer sound.

2Set paper to the printer.

This printer has three types of built-in paper sensors.

In case of label, set it so that label is positioned on the label light receiving sensor and label light emitting sensor. In case of black mark paper, set it so that the printable portion (other than black mark) is positioned on the black mark sensor. With this state kept, closing the printer cover causes ERROR LED to blink with the buzzer sound.

Label light emitting sensor

Black Mark sensor(BM1)

Label light receiving sensor

Black Mark sensor(BM2)

Black Mark sensor(BM3)

3Adjust the sensitivity of the paper sensor and measure the length of paper. Pressing the FEED switch causes label to be fed and paper sensor sensitivity adjustment and paper length measurement are carried out automatically. If the FEED button is pressed during the paper measuring, the result will be printed out as follows, and the printer memory switch will be initialized.

*The measuring result is a reference value

Label Length	: XXXmm	showing a label length
Gap Length	: XXmm	showing a gap between labels

< Example of label measuring result >