PRECAUTIONS IN HANDLING THE PRINTER
WARNING
Please observe the following precautions for power source and power cord:
●Do not plug or unplug the power cord with a wet hand.
●Use the printer only at the specified supply voltage and frequency.
●Use only the specified AC adapter with the printer.
●Check to make sure that the supply outlet from which the printer is powered has a sufficient capacity.
●Do not supply the printer from a power strip or current tap shared with other appliances.
●Do not plug the power cord into a supply outlet with dust or debris
left on its plug.
●Do not use a deformed or damaged power cord.
●Do not move the printer while the printer power is on.
• Neglecting to handle properly may result in printer failure, emission of smoke, fire, or electric shock.
• An overload may cause the power cord to overheat or fire or the circuit breaker to trip.
● Do not allow anything to rest on the power cord. Do not place the printer where the power cord will be trampled on.
● Do not use or carry the printer with its power cord bent, twisted, or pulled.
● Do not attempt to modify the power cord unnecessarily.
●Do not lay the power cord in the neighbor of a heating device.
•Neglecting these cautions may cause wires or insulation to break, which could result in leakage, electric shock, or printer failure. If a
power cord sustains damage contact your CITIZEN SYSTEMS dealer.
●Do not leave things around the supply outlet.
● Supply power to the printer form a convenient wall outlet, readily accessible in an emergency.
•The printer may not be immediately shut down in an emergency. ● Insert the power plug fully into the outlet.
● If the printer is not to be used for a long time, leave it disconnected from its supply outlet.
●Hold the plug and connector when plugging or unplugging the power cord or signal cable after turning off the printer and the appliance connected to it.
— 5 —
