Citizen Systems CT-S280 user manual Manual Setting of Memory Switch, Switch No Setting OFF

5.3 Manual Setting of Memory Switch

Memory switches can be set manually or by a command. For manual setting, refer to the next page.

The function of each memory switch is shown in the following table. (The white-on-black characters are factory setting.)

Switch No.	Setting			0 (OFF)			1 (ON)
Memory SW1-1	Power ON Info						Not send
						Send
Memory SW1-2	Buffer Size						45 bytes
			4k bytes
Memory SW1-3	Busy Condition							Full
				Full/Err
Memory SW1-4	Receive Error						Invalid
			Print “?”
Memory SW1-5	CR Mode							LF
				Ignored
Memory SW1-6	Reserved							−
						Fixed
Memory SW1-7	DSR Signal							Valid
					Invalid
Memory SW1-8	Reserved							−
						Fixed
Memory SW2-1	Reserved					−
								Fixed
Memory SW2-2	Reserved							−
						Fixed
Memory SW2-3	Spool print							Valid
					Invalid
Memory SW2-4	Full col print						WaitData
			LineFeed
Memory SW2-5	Resume aft PE						Print top
		Print next line
Memory SW2-6	Reserved					−
								Fixed
Memory SW2-7	Reserved							−
						Fixed
Memory SW2-8	PNE sensor						Invalid
						Valid
Memory SW3-1	Reserved							−
						Fixed
Memory SW3-2	Reserved							−
						Fixed
Memory SW3-3	Parallel 31 Pin						Invalid
						Valid
Memory SW3-4	Reserved							−
						Fixed
Memory SW3-5	Reserved							−
						Fixed
Memory SW3-6	Reserved							−
						Fixed
Memory SW3-7	CBM-270 mode				Invalid
								Valid
Memory SW3-8	Resum Open Err					Close	Command

— 26 —