Manual Setting of Memory Switch (Memory SW)
The memory switch can be selected, changed, or written by the combination of three actions: pressing the FEED switch, pressing and holding the FEED switch, and opening or closing the paper cover.
1.Entering memory switch setting mode.
Set paper to the printer and keep the printer cover open. With the FEED button pressed and held, turn the printer power on, and then press the FEED button twice. Close the cover. If the current settings of the memory switch etc. are printed, the printer is now in the memory switch setting mode.
| 0: | OFF state |
Memory SW (1) 00000000 | 1: | ON state |
(No indication for 0/1 with memory switch ranging from 7 to 10)
2.Selecting memory switch
When the FEED button is pressed short (within 2 seconds), printing occurs in the order of “Memory SW1” → “Memory SW2” → “Memory SW3” →
......“Memory SW10” → “Save To Memory” → “Memory SW1” → ......
repeatedly. When the memory switch you want to change is reached, press and hold the FEED button (for more than 2 seconds).
3.Selecting each switch item
| OFF state: ERROR LED OFF |
Power ON Info (Valid ) | ON state: ERROR LED ON |
(With memory switch ranging from 7 to 10, ERROR LED goes on only at the factory setting.)
4.Changing the setting
When the item you want to change is printed, press the FEED button short. The changed set value is printed. (When change of set value is repeated, the original set value is recovered). When you press the FEED button long, the set value is accepted and then the printer goes to the next setting item.
— 27 —