5.Returning to the memory switch select mode

When the setting of the desired content is completed, open the printer cover and then close the printer cover. This allows the printer to print the setting of the changed memory switch.

6.Saving the setting and exiting the memory switch setting mode

Press the FEED button short to move to “Save To Memory”. Then press and hold the FEED button. The printer prints the content of new setting and exits the memory switch setting mode to return to the normal standby state.

*Unless saving the setting is executed, the changed setting cannot be enabled.

7.Initializing the memory switch

When you want to return the memory switch setting to the initial state, go to “Save To Memory” in the above procedure. Here, open the printer cover and press and hold the FEED button till buzzer sounds. This allows the printer to return to the initial state.

*All the memory switches settings are returned to the factory set values.

5.3 Printing Paper

Use the print paper shown in the following table or the paper with equivalent quality.

Paper Type

Product Name

Recommended thermal

TF50KS-E2D from Nippon Paper

paper roll

KF50-HAD, PD150R, PD160R from Ohji Paper

 

F220VP, HP220A, F230AA from Mitsubishi Paper

 

 

 

Paper width 80 +01

 

 

Paper width 58 +01

 

4

Maximum print area 72

4

4

Maximum print area 48

6

 

 

 

 

 

φ83orless

Printing surface

ø18

ø12

65~75 m

Unit: mm

CAUTION!

Use the paper with the start of winding to roll core is as shown below.

No fold line is present and paper is along the inner diameter.

No turnup is present.

No pasting to core is present.

Outer winding (print side out) is used.

— 28 —